Preparing Two Specialty Coffees; Permanently Setting The Amount Of Water For The Cup Size - Jura X8 Instructions For Use Manual

Preparing two specialty
coffees
Permanently setting the
amount of water for the
cup size
To prepare two specialty coffees / specialty coffees with milk, press
the appropriate preparation button twice (within approximately
2 seconds).
Example: Proceed as follows to prepare two espressi.
Precondition: The start screen is displayed.
T Place two cups under the coffee spout.
T Press the 'Espresso'
preparation.
'2x Espresso', the preset amount of water flows into the
cups.
Preparation stops automatically. Your X8 is once more ready
for use.
It is easy to permanently adjust the amount of water for all single
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
T Place a cup under the dual spout.
T Press and hold the
Press button'
T Release the 'Coffee'
Preparation starts and the coffee flows into the cup.
T Press any button except
coffee in the cup.
Preparation stops.
set amount of water for one coffee is permanently stored.
Your X8 is once more ready for use.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amounts for all single
products in programming mode (see Chapter 4 'Permanent
settings in programming mode – Adjusting the product
settings').
button twice (within 2 seconds) to start
'Coffee' button until
appears.
button.
'Cancel' as soon as there is sufficient
'Saved' appears briefly on the display. The
2 Preparation
'Enough coffee?
17