Installing The Batteries - Toro Workman MDE 07299 Operator's Manual

Note: Position the steering wheel on the shaft
so that when the tires of the machine are pointed
straight ahead, the cross beam of the steering wheel is
horizontal and the thicker spoke of the steering wheel
is pointing down.
4. Assemble the washer and lock nut threads of the
steering shaft (Figure
5. Torque the nut to 24-29 N-m (18-22 ft-lb).
6. Align the lock tabs of the center cover to the openings
in the steering wheel and press the cover into the wheel
until the locks tabs snap into place
2

Installing the Batteries

Model 07299TC
Parts needed for this procedure:
2 Battery hold down
2 Battery hold-down rod
7 Battery cables
4 Battery-tray pads
1 Battery pad
2 Flange nut (3/8 inch)
1 Battery-terminal-protector spray
Procedure
Battery type: Trojan T105 or T145, or US Battery US2200
or US145.
Battery Specification: 6V 225AH @ 20hr rate
Dimensions: (L x W x H) 26.4 x 18.1 x 26.5 cm (10-3/8 x
7-1/8 x 10-7/16 inches)
1. Turn the key switch to the Off position and remove
the key.
2. Install the battery-tray pads into the rear-frame
assembly (Figure 4).
3).
(Figure 3).
1. Battery-tray pads
2. Rear-frame assembly
3. Remove the adhesive strip from the back of the battery
pad and install it onto the front inside face of the rear
frame (Figure 5).
Note: The pad should be approximately 6 mm (1/4
inch) below the bottom edge of the upper set of cutout
holes (Figure 5).
1. Battery pad
2. Front inside face
4. Install the batteries
Note: Pay attention to the battery polarity when
installing the new batteries
13
Figure 4
Figure 5
3. Upper cutout holes
(Figure 6).
(Figure 6).