Product Overview
1. Hood latch
2. Parking brake handle
Controls
1. Steering wheel
2. Cup holder
3. Passenger handhold
4. Brake pedal
3. Cargo box
4. Towing tongue
Figure 9
5. Accelerator pedal
6. Parking brake handle
(center console)
7. Operator's Manual storage
tube
Figure 8
5. Gear shift selector
6. Fuel cap
Accelerator Pedal
The accelerator pedal
to vary the engine and ground speed of the machine when
the transmission is in gear. Pressing the pedal increases the
engine rpm and ground speed. Releasing the pedal decreases
the engine speed and ground speed of the machine.
Brake Pedal
The brake pedal is used to apply service brakes to stop or
slow the machine
(Figure
CAUTION
Brakes can become worn or can be incorrectly
adjusted resulting in personal injury.
If the brake pedal travels to within 25 mm (1 inch)
of the machine floor board, the brakes must be
adjusted or repaired.
Parking Brake
The parking brake is between the seats
you shut off the machine, set the parking brake to prevent
the machine from accidental movement. To set the parking
brake, pull back the lever. To release the parking brake, push
the lever forward. If the machine is parked on a steep grade,
make sure that you set the parking brake.
16
7. Cargo box lever
(Figure
9) gives the operator the ability
9).
(Figure
9). Whenever