Installing The Seats; Installing The Seats; Installing The Hitch; Installing The Hitch - Toro 07280TC Operator's Manual

Installing the Seats

Insert the seat bracket into the seat base opening and pivot
the seat downward (Fig. 6).
2
Figure 6
1. Seat bracket

Installing the Hitch

1. Remove the 4 bolts and nuts from the inside rear of the
frame.
2. Align the hitch with the mounting holes on the frame.
Secure the hitch with the screws and nuts (Fig. 7).
1
Figure 7

1. Hitch

Installing the Batteries

Toro recommends the use of either Trojan T105 or T145, or
US. Battery US2200 or US145.
Battery Specification: 6V 225AH @ 20hr rate
Dimensions: (LxWxH) (10-1/4 x 7-1/8 x 11-1/4 inches)
1. Turn the key switch to the Off position and remove the

key.

1
2. Seat base
2
2. Left pivot bracket
16
2. Install the battery tray pads into the rear frame assembly
as shown Figure 8.
1
2
Figure 8

1. Battery tray pads

3. Remove the adhesive strip from the back of the battery
pad and install it to the front inside face of the rear
frame as shown in Figure 9.
Note: The pad should be approximately 1/4 inch below the
bottom edge of the upper set of cut-out holes (Fig. 9).
1
2
Figure 9

1. Battery pad

2. Front inside face
4. Install the batteries as shown in Figure 10.
Note: Pay attention to the battery polarity when
installing the new batteries (Fig. 10).
m–7647
2. Rear frame assembly
3
m–7646
3. Upper cut-out holes