Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Steering Wheel
Model 07299TC
Parts needed for this procedure:
1
Steering wheel
Procedure
1. Through the openings in the back of the steering
wheel, release the lock tabs of the center cover and
remove the cover from the wheel
Description
Steering wheel
Battery hold down
Battery hold-down rod
Battery cables
Battery-tray pads
Battery pad
Flange nut (3/8 inch)
Battery-terminal-protector spray
No parts required
No parts required
Operator's Manual
Parts Catalog
Safety training material
Registration card
Predelivery Inspection Form
Certificate of Quality
Key
(Figure
3).
Qty.
Install the steering wheel (model
1
07299TC).
2
2
7
4
Install the batteries (model 07299TC).
1
2
1
Set the charger voltage (model 07299TC
–
only).
Check the fluid levels and tire air
–
pressure.
1
1
1
Read the Operator's Manual and view
1
the training material before operating
the machine.
1
1
2
1. Steering shaft
2. Dust cover
3. Steering wheel
4. Tab slots in wheel
2. Remove the lock nut and washer from the steering
shaft
(Figure
3).
3. Align the steering wheel onto the splines of the steering
shaft
(Figure
3).
12
Use
Figure 3
5. Washer
6. Lock nut
7. Center cover
8. Opening (for access to the
steering wheel tabs)