Replacing The Fuses - Toro Workman MDE 07299 Operator's Manual

Figure 38
3. Disconnect the main positive-battery cable (red) that
connects the bank of batteries to the main fuse of the
machine (Figure 38).
Replacing the Batteries
1. Remove all of the battery-interconnect cables from the
batteries.
2. Remove the battery retainers located between the
batteries.
3. Remove all of the batteries and recycle them according
to your local codes.
4. Assemble new batteries into the machine at the
locations from where you removed batteries in step 3.
Note: Pay attention to the battery polarity when
installing the new batteries
5. Install the battery retainers and torque the nuts to 17 to
22 N-m (150 to 200 in-lb).
6. Connect the batteries together as shown in
with the battery-interconnect cables that you removed
in step 1.
Connecting the Batteries
1. Connect the main positive-battery cable (red) that
between the bank of batteries and the machine
38).
2. Connect the main negative-battery cable (black)
between the bank of batteries and the machine
38).
3. Torque the nuts securing all of the battery cables to
13.5 to 21 N-m (120 to 180 in-lb).
4. Coat the battery terminals with Toro battery-terminal
protector.
5. Ensure that the rubber boots on each battery cable are
securely seated over the battery terminals.
(Figure 38).
Figure 38
(Figure
(Figure
6. Insert the key into the K
switch to the O
N
7. Lower the cargo box, rotate the K
O position, and remove the key.
FF
Storing the Batteries
Charge the batteries fully before placing the machine into
storage. Plug the charger into a wall outlet while the machine
and batteries are in storage. Leave the charger plugged into a
wall outlet and charging receptacle during storage to ensure
that the batteries stay charged and do not freeze; otherwise,
charge the batteries at least once every 3 months.

Replacing the Fuses

There are 2 fuses in the electrical system. They are located
beneath the dash on the driver's side
Open
Power Point
Lights and Horn
2
G021810
1. Machine fuse holder
34
S and rotate the
EY WITCH
position.
S
EY WITCH
(Figure 39).
1
Figure 39
2. Relay
to the
10 A
10 A
10 A