Greasing The Front Wheel Bearings - Toro Workman MDE 07299 Operator's Manual

Greasing the Front Wheel
Bearings
Service Interval: Every 300 hours
Grease specification: Mobilgrease XHP™-222
Removing the Hub and Rotor
1. Lift the front of the machine and support it with jack
stands.
2. Remove the 5 lug nuts that secure the wheel to the hub
(Figure 30).
1. Lug nut
2. Wheel
3. Remove the flange-head bolts (3/8 x 1 inch) that secure
the bracket for the brake assembly to the spindle and
separate the brake from the spindle
Note: Support the brake assembly before proceeding
to the next step.
Figure 30
3. Hub
(Figure 31).
1. Caliper bracket (brake
assembly)
2. Spindle
4. Remove the dust cap from the hub
1. Dust cap
2. Nut retainer
3. Spindle nut
5. Remove the cotter pin and hut retainer from the
spindle and spindle nut
6. Remove the spindle nut from the spindle, and separate
the hub and rotor assembly from the spindle
32 and Figure 33).
30
Figure 31
3. Flange-head bolts (3/8 x
1 inch)
(Figure 32).
Figure 32
4. Tab washer
5. Spindle
6. Cotter pin
(Figure 32).
(Figure