Toro Workman MDE 07299 Operator's Manual page 37

Figure 42
Left, front wheel shown from the front; the angle is
exaggerated for illustrative purposes
1. Measure here
2. Measure here—should be 2.3 mm (0.09 inch) larger than
the measurement at 1
2. Measure from the same part of the rim on the top and
bottom of the tire to the square
Note: The distance of the bottom measurement
should be 2.3 mm (0.09 inch) larger than the top
measurement. Complete the measurement on both
front tires before adjusting.
Complete the following procedure for each tire that
needs adjusting:
3. Using tool Toro 6010, rotate the collar on the shock
absorber to change the length of the spring
•
If the bottom measurement was too short, reduce
the length of the spring.
•
If the bottom measurement was too long, increase
the length of the spring.
1
2
g014968
(Figure 42).
(Figure 43).
37
1
2
Figure 43
1. Shock-absorber spring
2. Collar
4. On a level surface, roll the machine straight back 2 to 3
m (6 to 10 ft) and then straight forward to the original
starting position.
5. Repeat this procedure, starting with step
camber is set correctly for both front wheels.
6. Measure the distance between both of the front tires at
the axle height at both the front and rear of the front
tires (Figure 44).
G009235
2
Figure 44
1. Tire center line—back
2. Tire center line—front
7. If the measurement does not fall within 0 to 6 mm (0
to 1/4 inch), loosen the jam nuts at both ends of the
tie rods (Figure 45).
3
G014994
3. Spring length
1 until the
1
3
3. Axle center line