Fault Indicator On The Sender; Fault Indicator On The Receiver - SICK deTec2 Core Vibes Operating Instructions Manual

8024476/2019-06-18 | SICK
Subject to change without notice
Table 6: Fault indicator on the sender
LED
PWR ERR
o o
Red
o Ö
Yellow Red
O Ö
Yellow Red
Ö Ö
o LED off. Ö LED flashes. O LED illuminates.
Receiver
Position of LEDs: see "Receiver indicators", page
Table 7: Fault indicator on the receiver
Light emitting diodes
OSSD ERR Alignment quality
1 2
Red Red
O Ö Ö o
Blue
Possible cause
No operating voltage or
operating voltage is too low
or internal fault
The voltage was too high
when operating the sender.
Fault in the supply voltage
The sender identified an
internal fault.
13.
Possible cause
3 4
An internal fault has
o o
occurred.
O P E R A T I N G I N S T R U C T I O N S | deTec2 Core Vibes
TROUBLESHOOTING
Troubleshooting
b Check the voltage sup‐
ply, see "Technical
data", page 54.
b Switch the voltage sup‐
ply off and then on
again.
b If the fault persists,
replace the sender, see
"Ordering information",
page 60.
b Check the voltage sup‐
ply, see "Technical
data", page 54.
b Replace the sender,
"Ordering information",
page 60.
b Check the voltage sup‐
ply and the power sup‐
ply unit, see "Technical
data", page 54.
b Switch the voltage sup‐
ply off and then on
again.
b If the fault persists,
replace the defective
components, see
"Ordering information",
page 60.
b Switch the voltage sup‐
ply off and then on
again.
b If the fault persists,
replace the sender, see
"Ordering information",
page 60.
Troubleshooting
b Switch the voltage
supply off and then
on again.
b If the fault persists,
replace the receiver,
see "Ordering infor‐
mation", page 60.
10
see
51