Connection Between Ap And Nodes - Advantech WISE-4210 Series User Manual

4.4

Connection between AP and Nodes

The first step of the connection between WISE-4210 end node devices and WISE-
4210-AP is to configure the units in the same network with the same frequency
range. Please go to "End Devices \ RF Status \ Configuration" to configure the RF
module by following the instructions below.
RF Operation Mode: WISE-4210 end node devices support "Push Mode",

communication from the end node device to AP is uplink only, no downlink.
 Data Rate (bps): Lower data rate is helpful of extending communication range,
while higher data rates can reduce the communication time which allows more
data to be uploaded to AP in the same period of time.
 Tx Power (dBm): Lower Tx power helps to reduce the power consumption and
extend longer battery life; higher Tx power enhances the communication dis-
tance.
 Baseband (kHz): If several WISE-4210-AP or sub-GHz networks are in the
same area, users can select different base bands to reduce the interference of
each network. Note that each WISE-4210 end node devices in the same net-
work should use the same baseband as WISE-4210-AP.
Once the network configuration is finished, go to "End Devices \ IO Status" for I/O
function configuration.
WISE-4210 Series User Manual 44