Playing Back Tapes Recorded In S-Vhs/Vhs Mode - JVC HM-DB1U Instructions Manual

16
EN
● Turn on the TV and select the AV mode.
● Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
VCR CABLE
TV /DBS
1 2
4 5
7 8
0
[REW (1 )]
[POWER]
3
6
9
[PLAY ( 3 )]
[FF ( ¡ )]
[STOP ( 7 )]
Playing back tapes recorded in
S-VHS/VHS mode
1
Load a cassette
Make sure the window side is up, the rear label
side is facing you and the arrow on the front of
the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
● The VCR turns on automatically.
● The counter is reset automatically, however, it is
not completely reset to "0:00:00".
● If the cassette's record safety tab has been
removed, playback begins automatically.
2
Start playback
Press [PLAY ( 3 )].
● Recording speed is automatically detected.
● If "VIDEO CALIBRATION" is set to "ON"
(default setting) and "PICTURE CONTROL" is
set to "AUTO": (
CALIBRATION" appears on the screen, and this
VCR checks the tape condition during
automatic tracking (only cassettes recorded in
the S-VHS, S-VHS ET or VHS mode).
To stop playback
Press [STOP ( 7 )] on the Remote or [STOP/EJECT ( 7/0)]
on the front panel.
To rewind the tape (when it is not running)
Press [REW ( 1 )].
To fast-forward (when it is not running)
Press [FF ( ¡ )].
To eject the tape
Press [STOP/EJECT ( 7/0 )] on the front panel when the
tape is not running.
● You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press [POWER].
PLAYBACK (cont.)
pg. 36), "VIDEO