Edit A Frequency; Adding A New Frequency To The List; Unit Info Page; Figure 24 - Microlite 2 Frequency Plans - Vislink Microlite 3 Operator's Manual

8.3.7.1.

Edit a Frequency

On the Frequency Plan page, click the 'pencil' icon next to the frequency to be changed.
Use the keypad to enter the frequency in MHz; do not use a decimal point. If the
frequency is in the wrong format or out of range a warning is displayed. Click the green
'checkmark' or 'save' icon to apply the changes. The new frequency will now show on the
frequency settings page.
To remove a frequency, click on the trash can icon.
8.3.7.2.

Adding a New Frequency to the List

The list cannot exceed 10 frequencies. Whenever a new frequency needs to be added, an
unused frequency must be deleted.
•
Click the add channel button at the bottom of the page.
• The Channel number is present by default.
• Enter the required frequency value without the decimal point
For example, enter 2031500, not 2031.500, and then click SAVE.

8.4. Unit Info Page

The unit info page contains two sections:
• Unit Information
•
Licensing
The Unit information contains the following information:
• Unit Name
• Serial Name
•
Model Number
•
Controller Version
•
Encoder Information
•
MAC Address
M55-ML3-UG, Rev A
Figure 24 – Microlite 2 Frequency Plans
Operators Manual
Operation
33