Advertisement
Step 5
Remove rear support bracket from main assembly.
Return to van, Place rear support bracket where you
previously marked.
Secure to floor using four 5/16" x 1.25" self tapping
screws.
Step 6
If desired, you can drill a clearance hole for a 1/4" bolt
into seat pedestal where previously marked. Or you can
wait and drill once the main assembly is placed back
into van.
Step 7
Place main assembly with front bracket back into van and bolt to previously installed rear support using
two 1/4" x 7/8" hex bolt, two 1/4" lock washers and two 1/4" flat washers.
*SNUG TIGHTEN
Step 9
Align and square the driver data file. Go back and TIGHTEN all bolts.
Your installation is now complete.
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Install Instructions
Step 8
If hole is not drilled in seat pedestal mount,
align bracket and do so now.
Bolt front bracket to seat pedestal mount
using a 1/4" x 7/8" hex bolt, two 1/4" flat
washers and one 1/4" nyloc nut.
Page 8
Advertisement
