Controls; Inverter Models Only - Raypak CROSSWIND Series Installation And Operation Manual

6. CONTROLS

Inverter Models Only

The Display controls general operation. The layout, main
functions and buttons are shown below.
HEATING
Figure 12. Operation Display, Models 30-I though 65-I
Symbol Designation
Press 3 seconds to unlock/lock
ON/OFF
Speed
Up
Down
Table E. Display Button Functions
Power On
Press the LOCK button for 3 seconds to light up screen,
then press POWER to power on the heater.
Adjust/Set Temperature:
When screen is unlocked, press UP
display or adjust the set temperature.
To change from Fahrenheit to Celsius, press the
the DOWN for 3 seconds.
Smart/Silent mode selection
Smart mode, as default, will be activated when the HEAT
PUMP is on, and the screen shows
Press FAN to enter Silent Mode. The display screen
will show .
NOTE: Select Smart Mode for initial heating.
COMPRESSOR
HEATING
CAPACITY %
Button Functions
screen
Power On/Off
Smart/Silent Mode
Temperature Adjustment
Temperature Adjustment
or DOWN
and
.
Screen Lock
If no button is used within 30 seconds, the screen will lock
automatically. At this point the backlight will turn off and 0%
will display.
Alternatively you can lock the display by pressing the
LOCK button for 3 seconds to achieve the same result.
To unlock the screen and use any other button, follow the
Power On instruction above.
Defrosting
Auto Defrosting:
1. When the heater is defrosting, HEATING
continually flash.
2. After defrosting, HEATING
Manual Defrosting:
1. When heater is heating, press FAN
together for 5 seconds to start manual defrosting,
will flash continuously.
After defrosting, HEATING
NOTE: Manual defrosting intervals should be more than
30 minutes and the compressor should run for more
than 10 minutes.
to
will
will stop flashing.
and MINUS
will stop flashing.
17