On/Off Models Only; Using The On/Off Display Unit - Raypak CROSSWIND Series Installation And Operation Manual

On/Off Models Only

The Display controls general operation. The layout, main
functions and buttons are shown below.
WATER TEMP
AND
TIME SETTING
MODE
TIMER
INDICATOR
LIGHT
TIMER ON
TIMER INDICATOR
LIGHT
Figure 13. Operation Display, Models 40-O through 65-O
Symbol Designation
Power
Clock
Timer Off
Light A Shows the auto-stop time being set
Timer On
Light B Shows the auto-work time being set
Shows the cool mode (for heat and
Cool
Heat
Heat or cool mode selection (only
MODE MODE Key
available in heat and cool machine)
Down-
Set required temperature and time
ALLOW
Up-ALLOW Set required temperature and time
LED screen
Table F. Display Button Functions

Using the On/Off Display Unit

Display defaults
• The LED screen will display the time when the
machine is off.
• The LED screen will display the current water
temperature in the pool when the machine is on.
18
Heat
Cool
TIMER OFF CLOCK POWER ON/OFF
Button Functions
Power Switch
Set local time
Set the time required machine
auto-stop
Set the time required machine
auto-work
cool models only)
Shows the heat mode
Display time, temperature and
machine failure code
Heat/Cool Mode
1. Press the MODE button to switch from one mode to
another.
NOTE: Available only in heat and cool models.
Setting pool water temperature
Temperature can be adjusted either when the machine is
on or off.
1. Press UP or DOWN
pool water temperature.
2. The numbers on the LED screen will flash during
adjustment.
3. After five seconds of inactivity, the LED will stop
flashing, the adjusted target temperature will be
saved, and the LED screen will revert to the default
display.
4. Later on, at any time, should you wish to check the
temperature, press UP
access its setting.
Setting the clock
1. The clock can be set either when the machine is on
or off.
2. Press CLOCK to set the time to your local time
zone. The displayed time on the LED screen will now
flash.
3. To set the hour press CLOCK
UP or DOWN
4. To set the minute press CLOCK
flashing and then press UP
5. After setting, press CLOCK
temperature will appears. After 30 seconds, it will
stop flashing and the LED screen will return to its
default.
Automatic on/off settings
The display can be programmed to turn the machine on
and off automatically.
Setting the ON time
1. Press CLOCK to access the timer function.
2. When the indicator light is on and the time is flashing,
press CLOCK again to set the hour. Use UP
or DOWN to adjust.
3. While the display is still flashing, press
minute. Use UP or DOWN
4. After adjustment, press TIMER ON
setting, and the water temperature will be displayed.
After 30 seconds, the controller display will be revert
to its default mode.
to set to your required
or DOWN again to
again then press
.
before it stops
or DOWN .
and the water
to set
to adjust.
to confirm the