Starting Procedure; Normal Starting - Monaco Cayman 2005 Owner's Manual

The fault code will flash in the following sequence:
• The yellow CHECK ENGINE lamp will flash.
• There will be a short one to two second pause.
• The fault code will flash on the red STOP ENGINE lamp.
• There will be a short one to two second pause between each number.
• When the number has finished flashing in STOP ENGINE, the CHECK ENGINE lamp
will appear again. The fault code will repeat the sequence.
Each fault code will flash twice before advancing to the next code.
When starting the engine, always use the following procedure.
1. Turn off the vehicle headlights and any other auxiliary equipment prior to starting to ensure
that all available battery power is available for the starter motor.
2. Ensure that the park brake is applied and that the transmission is in NEUTRAL.
3. Turn the ignition switch to the ON position.
4. Look at the dash warning lights; the CHECK TRANS light as well as the PARK BRAKE
light on should illuminate. The CHECK ENGINE light should illuminate and then cycle
off. If any of the warning lights fail to come on, investigate and correct the cause of the
problem. If the CHECK ENGINE light remains on, or re-illuminates after starting, the
engine ECM may have detected an engine systems fault. Refer to the diagnostics section of
the OEM Engine Manual for corrective action. If the CHECK TRANS fails to illuminate,
or remains on after starting, refer to the Transmission Operator's Manual for corrective
action.
5. The WAIT TO START light should illuminate, then go out.
6. Wait for all warning lights to cycle through diagnostics. Pressing the throttle or holding the
throttle down is not needed. Turn the ignition switch to the START position and crank the
engine. The electronic controls on the engine will automatically deliver the correct amount
of fuel for the engine to start.
Cayman 2005

STARTING PROCEDURE -

Chassis Information --- Section 10

Normal Starting

351