Heat Pump - Monaco Cayman 2005 Owner's Manual

Furnace Operation:
• Slide the On/Off switch (on hallway thermostat) to the On position.
• Press the Zone button to select Zone 1.
• Select the Furnace mode on the Comfort Control using the Mode button.
• Select the desired temperature using the Up and Down arrow buttons.
NOTE:
The Zone 2 function does not operate the furnace.
Heat Pump (Optional - N/A w/ Standard Thermostat)
The Heat Pump mode supplies heat by using the air conditioner. The air conditioning principle is
reversed, supplying heated air to the ceiling registers instead of refrigerated air.
NOTE:
The roof air conditioner will not operate in Heat Pump mode with ambient tempera-
tures at or below 30º F. Aux Heat mode will automatically be selected.
Heat Pump Operation:
When ambient temperature is between 30 to 42º F., a defrost cycle is initiat-
ed approximately every 40 minutes of compressor operation. The blower motor
will stop for five minutes and Defrost will be displayed. After the defrost cycle
the Heat Pump operation will resume.
• Slide the On/Off switch on the thermostat to the On position.
• Press the Zone button to select Zone 1 or optional Zone 2.
• Press the Mode button repeatedly until Heat Pump is displayed.
• Set desired fan speed by pressing the Fan button.
• Press the Up or Down buttons to set desired heating temperature.
Auxiliary Heat - If the Heat Pump mode is selected at or below 30° F., or if operating in Heat
Pump mode and temperature drops to 30º F., the air conditioner will stop Heat Pump operation and
Aux Heat will be displayed. The furnace will be selected as the auxiliary heat source and will begin
operation. The furnace will remain the primary heat source until ambient temperature rises above 42º F.
152
Section 4 --- Appliances
Furnace
050200b
Heat
Pump
050200b
Cayman 2005