Monaco Cayman 2005 Owner's Manual page 177

If the Slide Room Fails to Operate:
Check the fuse and auto-reset circuit breaker on the slide-out relay module located adjacent to the
inverter.
If the fuses and circuit breakers test okay, it will be necessary to manually override the slide-out
mechanism. Following the steps below to manually override the slide-out room:
WARNING:
Do not work on the slide-out system unless the battery is disconnected. Make sure
the floor is clean before retracting the slide-out room.
Manual Override for Bedroom Slide-out:
1. Lift up the mattress and unscrew baseboard to gain access to the slide-out cover board and mecha-
nism.
2. Remove 12 Volt DC from the motor by disconnecting the plug from the slide-out motor to the
power supply.
3. Push the brake lever to disengage the drive motor.
4. Turn the large hexnut, using a 3/4" wrench, to bring the slide out in.
5. Once the slide room has been manually retracted, return the brake level to its original position
to lock the room in place.
6. Take the motorhome to an authorized repair center.
Cayman 2005
020079f
Equipment --- Section 5
177