Service Clearances - Daikin Destiny VFD Series Installation And Maintenance Manual

Service Clearances

Leave adequate space around the unit for piping, coils, and
drains. Always have access to at least one side of the unit for
regular service and maintenance. See
space requirements. Routine maintenance examples include
filter replacement, drain pan inspection and cleaning, fan
bearing lubrication, and belt adjustment. Provide sufficient
space on the drive side of the fan and the connection side of
the coil for shaft and coil removal, if necessary (refer to the
"Coil Data" section in Catalog 580
sizes). Both the fan drive and coil can be field modified to
right or left hand to accommodate clearance restrictions. See
Reversing the Coil Handing on page 10
Belt Drive Package on page
Figure 2: Servicing Space Requirements
Vertical unit
Width
Horizontal unit
Width
IM 782-12 • DESTINY AIR HANDLERS
Figure 2 for servicing
for information about coil
and Reversing the
12.
Height
Height
For Bottom Filter Access Only
Provide 30 " Vertical Clearance for
Filter Removal
For routine maintenance, remove panels on either side of the
unit. See Panel Removal on page
are available for the fan and filter sections. Allow sufficient
space for service door(s) to swing completely open, or to
meet the clearance requirement of the section it accesses,
whichever is greater. Service doors are not interchangeable
with access panels on the opposite side of the unit. Determine
clearances before specifying doors.
Have at least 42" of clearance in front of electrical power
devices (starters, VFDs, disconnect switches, and combination
devices). Electrical power devices that are mounted on the side
of the unit typically are 6" deep, 12" maximum (see
Top view
Width
30.00"
Width of Width of
fan section oil section
C
6
Installation
8. Optional service doors
Electric power clearance
Horizontal unit
12" (maximum)
42"
42"
www.DaikinApplied.com
Figure 2).
Vertical unit
42"