Mvp Variable Speed Sheaves - Daikin Destiny VFD Series Installation And Maintenance Manual

MVP Variable Speed Sheaves

Mounting:
1. Verify that both driving and driven sheaves are in
alignment and the shafts are parallel. The centerline of
the driving sheave must be in line with the centerline of
the driven sheave. See
2. Before starting drive, verify that all setscrews are torqued
to the values shown in
setscrew torque and belt tension after 24 hours of service.
Figure 51: MVP Type Sheave Adjustment
www.DaikinApplied.com
Figure 51.
Table 38 on page 51. Check
Adjustable
center-flange
Split taper
bushing
Capscrews
(Do not remove.)
Adjusting:
1. Adjust motor base forward to release belt tension. For
easier adjustment, remove the belts.
2. Loosen, but do not remove both of the locking setscrews
A in the outer locking ring by using a hex key or torque
wrench with a hex bit.
3. Adjust sheave to desired pitch diameter by turning the
outer locking ring. Use a spanner wrench or drift inserted
into the three holes that are located 120° apart on the ring.
4. Any pitch diameter can be obtained within the sheave
range. One complete turn of the outer locking ring
changes the pitch diameter 0.233".
5. Do not open sheaves more than the following amounts:
— Do not open B sheaves more than 4, 3/4 turns for the
A belts or 6 turns for the B belts.
— Do not open C sheaves more than 9 1/2 turns.
— Do not open 5V sheaves more than 6 turns.
— Do not open 8V sheaves more than 8 turns.
6. Before operating the drive, tighten BOTH locking screws
A in the outer locking ring. Use a torque wrench and
tighten to the value shown in
7. Replace belts and adjust the motor base to tension the
belts properly. See
50.
8. Do not loosen any screws other than the two locking
screws A in the outer locking ring when adjusting the
sheave pitch. Do not operate the drive until the locking
screws are set to the torque specifications.
Fixed
(2) Locking
center-flange set screws A
Outer
locking-ring
Stationary
Inner locking-ring
end-flange
49
Service and Maintenance
Table 38 on page
Fan Drive Belt Adjustment on page
Flathead socket screws
(Do not remove.)
(3) Holes for
spanner wrench
or drift
IM 782-12 • DESTINY AIR HANDLERS
51.