Grandhall Freedom 450 Operating And Assembly Instructions Manual page 2

2
G E N E R A L
TABLE OF CONTENTS
General Information
Safety
Outdoor Areas
Pre-Assembly
Assembly:
Inspection
Assembly – General:
Operation:
Fault Finding
Maintenance
Parts Diagram / List
Contacts
FOR CUSTOMER REFERENCE
(Record and file in a safe place)
Purchased from
Date purchased
Serial No.
NOTE: Sales docket must be kept as proof of purchase date.
Appliances for use with bottled gas are labelled 'Universal LPG' or
'Propane'. Appliances for use with natural gas are labelled 'Natural Gas'
and must be installed by an authorised person. Check the gas type sticker
attached to the appliance. Check that the label matches the gas type to
be used.
Your Outdoor Range Barbecue is preset at the factory to operate on
bottled gas only, unless specified otherwise.
• FAILURE TO COMPLY WITH THESE
INSTRUCTIONS COULD RESULT IN A FIRE
OR EXPLOSION WHICH COULD CAUSE
SERIOUS BODILY INJURY, DEATH OR
PROPERTY DAMAGE.
• ACCESSIBLE PARTS MAY BE VERY HOT.
• KEEP YOUNG CHILDREN AWAY.
• ANY MODIFICATION OF THIS
APPLIANCE MAY BE DANGEROUS.
• DO NOT MOVE THIS APPLIANCE
DURING USE.
• TURN OFF THE GAS SUPPLY AT THE GAS
CYLINDER AFTER USE.
• READ THE INSTRUCTIONS BEFORE USING
THE APPLIANCE.
• PARTS SEALED BY THE MANUFACTURER
MUST NOT BE ALTERED IN ANY WAY.
• THIS BARBECUE IS ONLY TO BE
USED OUTDOORS.
SPECIFICATIONS
Appliance specifications can be found on the data label attached to the side
panel of the appliance body.
I N F O R M A T
GAS INSTALLATION CODES
This appliance is certified to AS 4557 by the Australian Gas Association.
2
and must be used in accordance with the installation requirements of your
3-4
local gas supply authority, and the appropriate installation standard
5
AS5601.
6
7-9
10
CLEARANCES
11-15
16-17
The following minimum clearances from combustible materials must be
18
maintained when appliance is in use:
19-21
top – 1000 mm, rear – 450 mm, sides – 250 mm.
Openings at the rear and sides of the appliance provide air for
22-23
combustion and must not be obstructed.
24
HOSE AND REGULATOR SAFETY
NEVER OPERATE THIS BARBECUE
WITHOUT A REGULATOR.
The regulator and hose assembly supplied with the barbecue are suitable
for use with bottled gas.
This regulator is adjusted to have an outlet pressure of 2.75 kPa for
connection to a gas cylinder only. The regulator and hose assembly
supplied with the appliance must be used. Replacement regulator and
hose assemblies must be those specified by the appliance manufacturer.
When connecting the hose and regulator assembly to the gas cylinder,
take care to avoid unnecessary twisting of the flexible hose. Also, take
care to avoid a loose connection with the gas cylinder. After the assembly
has been secured, turn on the gas and check for leaks by brushing a liquid
detergent and water solution over all visible and accessible gas line
connections. Include checking those connections which were made by
your supplier. The presence of bubbles will indicate a gas escape.
DO NOT TEST FOR GAS ESCAPES WITH AN OPEN FLAME.
If you are unable to correct the leak by tightening the connections,
turn off the gas and contact your place of purchase immediately.
Always ensure the appliance is kept away from flammable materials
and the gas cylinder clear of any heat source. When changing over from
an empty gas cylinder to a full one, make sure this procedure is carried
out in a flame free atmosphere.
Inspect the gas hose assembly when exchanging the gas cylinder,
or at least once a year, whichever is more frequent. If the 'O-Ring' or PVC
hose is cracked, cut, abraded or damaged in any way, the appliance must not
be operated. The complete assembly must be replaced if damaged and
when statutory conditions require it. Contact your place of purchase if
uncertain.
OVERALL DIMENSIONS
Height – Lid closed 935 mm. Lid open 1590 mm
Width – 665 mm
Depth – Lid closed 660 mm. Lid open 780 mm
I O N
2