Grandhall Freedom 450 Operating And Assembly Instructions Manual page 14

14
FINAL ASSEMBLY STEP
When you have finished assembling your Outdoor Range Barbecue
be sure that all screws are tightened for safe operation of your
barbecue.
IMPORTANT: Wash all stainless steel surfaces with
mild detergent and warm water to remove any
processing oils. Rinse with clean cold water then
dry. Do not use any abrasive cleaners or cloths that
may scratch the surface.
NOW YOUR OUTDOOR RANGE BARBECUE IS
READY TO USE
Before first use:
1. Please read 'Safety', 'Lighting' and 'Operating' instructions
carefully.
2. Check and ensure the gas cylinder is full.
3. Ensure all connections are securely tightened. Check for gas
leaks. Refer to page 4.
At the beginning of each barbecue season:
1. Check gas valve orifices, burner tubes and burner ports for
any obstructions. eg. spiders, webs, insects.
• CONTENTS OF GREASE DRAINING
TRAY AND GREASE RECEPTACLE MAY
BE VERY HOT DURING COOKING.
• ALLOW TO COOL COMPLETELY
BEFORE DISPOSING OF THE
CONTENTS.
• AFTER CONTINUOUS USE, FAT AND/
OR COOKING JUICES MAY BUILD UP.
TO AVOID ANY FLARE-UPS, IT IS
RECOMMENDED THAT THE GREASE
TRAY AND RECEPTACLE BE EMPTIED
REGULARLY.
• NOTE: GREASE / FAT FIRES ARE NOT
COVERED BY WARRANTY.
• LIDS MUST BE IN THE OPEN POSITION
FOR LIGHTING.
• DO NOT SMOKE AT ANY TIME WHEN
ATTEMPTING TO IGNITE APPLIANCE.
• CAUTION: DO NOT MOVE TROLLEY
WHILE APPLIANCE IS IN OPERATION.
• NEVER LEAN OVER THE APPLIANCE
COOKING AREA WHILE LIGHTING THE
APPLIANCE.
• KEEP YOUR FACE AND BODY AT A
SAFE DISTANCE (AT LEAST 450 mm)
FROM THE MANUAL LIGHTING HOLE
OR BURNERS.
• CAUTION: DO NOT LEAVE THE
APPLIANCE UNATTENDED WHEN
BURNER/S IS ALIGHT.
A S S E M B L Y – G E N E R A L
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE
Familiarise yourself with the general information and safety
guidelines located at the front of this booklet. Check to see that
gas cylinder is filled and that end of each burner tube is properly
located over each valve orifice. Set burner controls to 'OFF'
position.
ENSURING BURNER CONTROLS ARE OFF
IMPORTANT: Before connecting and disconnecting
appliance to gas source, ensure burner controls are
in 'OFF' position.
NOTE: The 'OFF' position on the control panel is
identified by either a small black dot / a short vertical
black line / or the word 'OFF'.
When the marking, or the word 'OFF' printed on
the control knob, aligns with the printed marking on
the control panel, then the burner is in the fully off
position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
TEST FOR LEAKS WITH A LIQUID
DETERGENT SOLUTION, NEVER WITH
AN OPEN FLAME (Refer to page 4)
• DISCONNECT AND REMOVE GAS
CYLINDER WHEN MANOEUVRING THE
APPLIANCE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS.
• IF THIS INFORMATION IS NOT
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
• DO NOT STORE A SPARE GAS
CYLINDER UNDER OR NEAR THIS
APPLIANCE.
• THIS APPLIANCE IS ONLY TO BE
USED OUTDOORS.
14