Grandhall Freedom 450 Operating And Assembly Instructions Manual page 15

15
CONNECTING TO GAS SOURCE
1. Screw the wing bolt and special nut to trolley bottom shelf or
gas cylinder pull-out tray.
NOTE: The special nut may be omitted for gas
cylinders with larger bases.
Special nut 1 / "
4
Qty. 1
A S S E M B L Y
Wing bolt 1 / " x 6 5 /
4
Qty. 1
– G E N E R A L
2. Ensure hatch in trolley top panel is closed to secure gas
hose. Refer page 9.
3. Place the gas cylinder on the ground in front of the appliance.
4. Attach cylinder connection
device of regulator and hose
assembly to cylinder
valve outlet.
Tighten firmly.
5. Open the gas
cylinder valve
1/4 to 1/2 open to allow
gas to flow.
6. Leak test all accessible
connections thoroughly,
including the connection to the
gas cylinder, using a liquid detergent water solution
prior to lighting the barbecue.
Refer to 'Safety' information, pages 3 - 5.
7. If a leak is found, turn gas cylinder valve off and do not use
barbecue until repairs or replacement can be made.
8. Install the gas cylinder into the trolley so that the cylinder
valve faces to the front.
9. Secure the gas cylinder with the wing bolt.
DISCONNECTING FROM GAS SOURCE
1. Turn the burner control 'OFF'.
2. Turn the gas cylinder valve off fully.
3. Detach the regulator assembly from gas cylinder valve.
Protect the connection end of the regulator from damage.
NATURAL GAS INSTALLATION
"
16
This appliance is also certified for use on natural gas. Contact
the manufacturer for advice in relation to using this appliance on
natural gas. Refer to back cover.
Appliances for use on natural gas must be installed by an
authorised person.
15
Direction for
tightening