Grandhall Freedom 450 Operating And Assembly Instructions Manual page 18

18
SHOULD A FLASHBACK FIRE OCCUR
IN OR AROUND BURNER TUBES,
FOLLOW THE INSTRUCTIONS BELOW.
FAILURE TO COMPLY WITH THESE
INSTRUCTIONS COULD RESULT IN:
• A FIRE OR EXPLOSION THAT COULD
CAUSE SERIOUS BODILY INJURY,
DEATH, OR PROPERTY DAMAGE.
• SHUT OFF GAS SUPPLY TO
APPLIANCE.
• TURN THE CONTROL KNOBS TO OFF
POSITION.
• OPEN THE APPLIANCE LID.
PUT OUT ANY FLAME WITH A FIRE
EXTINGUISHER.
• ONCE THE APPLIANCE HAS COOLED
DOWN, CLEAN THE BURNER TUBES
AND BURNERS ACCORDING TO THE
CLEANING INSTRUCTIONS IN THIS
OPERATOR'S MANUAL.
CAUTION: If burners go out during operation, close
gas supply at source, and turn all gas valves off.
Open hood and wait 5 minutes before re-attempting
to light (this allows accumulated gas fumes to
clear).
CAUTION: Should grease fire occur, close gas supply
at source, turn off all burners and remove food until
fire is out.
KEEP THE VENTILATION OPENINGS OF THE
CYLINDER ENCLOSURE FREE AND CLEAR FROM
DEBRIS.
F A U L T F I N D I
IF THIS APPLIANCE FAILS TO LIGHT
1. Turn gas off at source and turn burner control knobs to
'OFF'. Wait at least five (5) minutes for gas to clear, then
retry.
2. If your Outdoor Range Barbecue still fails to light, check gas
supply and connections.
3. Repeat lighting procedure. If the appliance still fails to
operate, turn the gas off at source, turn the control knobs to
'OFF', then check the following:
•
MISALIGNMENT OF BURNER TUBES
OVER ORIFICES
Correction: Reposition burner tubes over orifices.
•
OBSTRUCTION IN GAS LINE
Correction: Remove fuel line from appliance.
smoke! Open gas supply for one second to clear any
obstruction from fuel line. Close off gas supply at source
and reconnect fuel line.
•
PLUGGED ORIFICE
Correction: Remove burners. Carefully lift each burner up
and away from gas valve orifice. Remove the orifice from
gas valve and gently clear any obstruction with a fine wire.
Then reinstall all orifices, burners and cooking components.
If an obstruction is suspected in gas valves or manifold,
contact your place of purchase or manufacture.
•
OBSTRUCTION IN BURNER TUBES
Correction: Follow burner tube cleaning procedure on page 21
of this operator's manual.
•
MISALIGNMENT OF IGNITER ON BURNER
Correction: Check for proper position of electrode tip as
shown on page 9. The gap between spark electrode tip and
spark receiver should be approximately 4 - 5 mm. Adjust if
necessary. With gas supply closed and all control knobs
set to 'OFF' press the electric igniter cap and check for the
presence of a spark at electrode.
•
DISCONNECTED ELECTRIC WIRES
Correction: Inspect the igniter junction box found behind the
control panel. Connect loose electric wires to junction box
and try to light appliance.
•
WEAK AA BATTERY
Correction: Unscrew igniter cap and replace battery.
N G
18
Do not