Grandhall Freedom 450 Operating And Assembly Instructions Manual page 10

10
INSTALL IGNITER BATTERIES
• Unscrew igniter cap from control panel.
• Place supplied AA battery into the igniter slot with positive
pole facing you.
• Position the cap and spring over the AA battery and tighten
onto control panel.
AA
battery
Igniter
cap
Contact
WITH THE ASSISTANCE OF ANOTHER
PERSON, PERFORM THIS ELECTRODE
CHECK BEFORE PROCEEDING.
This test will ensure that the spark electrode tips are properly
positioned so your barbecue lights easily and properly.
4-5 mm spark
gap
Spark electrode tip
Spark receiver
Ensure gas source is turned off or is disconnected and all burner
control knobs are set to 'OFF'. Open the lid and remove the hot
plate. Push the electronic igniter. You should hear a 'clicking'
sound. You should see a blue spark within the gas collector
box. If a spark is present the electrode tips are properly positioned.
I N S P E C T I O N
Spring
Gas collector
box
Inside nut
If no spark is seen, the spark gap needs to be
adjusted as follows:
• Using an adjustable spanner, loosen the inside nut until the
gas collector box can be turned upward. If the gap between
the spark electrode tip and receiver is more than 4 - 5 mm use
long nose pliers to gently squeeze the gas collector box to
narrow gap. Return the gas collector box to its original
position, secure the inside nut and try the electrode check
again.
If no 'clicking' sound is heard:
• AA battery may be installed backwards.
• Electric wires may be loose. Remove the AA battery and
inspect the igniter junction box found behind the control
panel and reconnect any loose wires.
• CHECK PERFORMANCE OF
BURNERS PRIOR TO INSTALLING
HOT PLATE COMPONENTRY. Refer
pages 16, 17 for lighting instructions
-
• DO NOT SMOKE WHEN ATTEMPTING
+
TO IGNITE BARBECUE.
• NEVER USE VOLCANIC ROCK,
HEAT BEADS OR OTHER MATERIAL.
• ALWAYS USE PROTECTIVE GLOVES
WHEN HANDLING HOT COMPONENTS.
SIDE BURNER ELECTRODE CHECK
• Open lid.
• Push electronic ignition button. Look for a spark between tip
of electrode and burner.
• If you don't see a spark from pot burner electrode, adjust
gap between electrode and burner surface to 4 - 5 mm.
10