Orion OLMU-K4940 User Manual page 22

1. MENU button
– OSD MENU will be displayed by pressing MENU button.
ON OFF
Info
Mute
Picture
1 2 3
Timer
4 5 6
BC On
7 8 9
BC Off
Backlight Brightness
0
MENU
EXIT
2. Direction buttons for movement
OK
MODE DICOM
DP Opt. QUAD Prog.1
HDMI1 HDMI2 PIP
Prog.2
HDMI3 HDMI4 PBP Prog.3
3. EXIT button
– Press EXIT button to exit from the MENU after adjustment.
4. INFO button
– The display information for the screen at the moment is displayed at the upper left
corner of the screen.
ex) Input DP
5. BC On/BC Off button
- To control all MLCDs, just press "BC ON" button. After then,
IR control is applied to the all MLCD.
- To control one MLCD plugged IR only, just press "BC Off, then
IR control is applied to one MLCD plugged IR.
- 40 -
M
UL
TI
Input Multi-Display
Other
Contrast Sharpness
‚
DP
3840x2160@60Hz
HDCP Disabled
GROUP ID 1
MONITOR ID 1
6. How to control only one MLCD in multi-configuration
– With each set's ID set, it's about controlling one set with the remote
▶ Entering individual control mode.
ON OFF
Info
- key combination :
Mute
1 2 3
Ex) pop up the OSD menu on ID 3 MLCD
Timer
- Prog1.key > UP key > OK key > 0 key > 0 key > 3 key > menu key
4 5 6
BC On Then, the OSD menu pops up only in the ID 003 MLCD. IF you change
7 8 9
the SET, push the ID key(3 digits) in this mode.
BC Off
0
MENU UP key
EXIT
OK key
OK
MODE DICOM
DP Opt. QUAD Prog.1
Prog.1 key
HDMI1 HDMI2 PIP
Prog.2
Prog.3 key
HDMI3 HDMI4 PBP Prog.3
▶ Exiting individual control mode.
- key : Prog.3 key
- IF you exit the individual control mode, just press the Prog.3 button.
7. How to install the Battery
•Open the battery compartment cover on the back side and insert the batteries with correct polarity.
Battery Installation
•Install two 1.5V alkaline batteries of AAA type. Don't mix used batteries with new batteries.
Prog.1 key – UP key – OK key - ID key(3 digits)
- 41 -