Furuno IC-350 Operator's Manual page 5

Precautions for the installer
WARNING
Shut off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
equipment is powered while it is being
installed.
Use only the specified power cable.
Fire or electrical shock can result if a
different cable is used.
Do not install the equipment where it
can get wet from rain or water splash.
Fire or electrical shock can result if water
gets inside the equipment.
CAUTION
Be sure the voltage at the ship's switch-
board is compatible with the voltage
rating of this equipment.
The rated voltage of this equipment is
24 VDC. Damage to the equipment can
result if the equipment is connected to an
incompatible power supply.
Observe the compass safe distances
shown below to prevent interference to
a magnetic compass.
Standard compass: 1.20 m
Steering compass: 0.75 m
iii
SAFETY INSTRUCTIONS