Advertisement
Replacing a 3.5-inch Drive
Removing a Drive
1.
Check the RAID configuration of the drive to be
removed.
2.
Determine the location and numbering of the
drive to be removed.
3.
Press the ejector release button on the drive.
See (1) in the figure. The ejector lever
automatically ejects.
4.
Completely raise the drive ejector lever. See (2)
in the figure.
5.
Pull out the drive for about 3 cm (1.18 in.). Wait
for at least 30 seconds until the drive stops
operating, and remove the drive from the slot.
6.
Place the removed drive in an ESD bag.
7.
(Optional) Install a filler module in the drive slot
if you do not want to install a drive immediately.
Copyright © Huawei Technologies Co., Ltd. 2020
Page 71
Advertisement
