Information And Settings; Displaying Information; Displaying Settings - Siemens TK76K573 Instruction Manual

de en

Information and settings

Use (7) to display information (press
i
briel y) and adjust settings (hold down for at
least three seconds).

Displaying information

In the Info menu (press
can call up the following information:
► when it is necessary to descale the
appliance
► when it is necessary to clean the
appliance
► when it is necessary to change the i lter
► how much coffee has been dispensed
since the appliance was i rst put into
operation
► how many milk drinks have been
dispensed
► how much hot water has been prepared
Information / Service
....................................................................................

Displaying settings

Hold down (7) for at least 3 seconds;
i
the different setting options are then
displayed:
Default settings
Language:
English
Use and
<
the different setting options. The currently
active setting is always highlighted in white.
You can change the setting that is currently
displayed by turning the rotary knob
To exit the menu, press
44
TK76K573_Heft1.indb 44
(7) briel y) you
i
Descale after
100 cups
Per-cup quantities
(3) to switch between
>
(4).
i (7) again.
The changes you have made
are saved automatically. It is
not necessary to coni rm them
additionally.
The following setting options are available
to you:
: Turn the knob
> Language
select the display language.
> Per-cup quantities
quantity can be set separately for each
type of drink and each cup size (see "Set
per­cup quantity" on page 45).
> Water hardness
(4) to select the required water hardness
(1, 2, 3 or 4) (refer also to "Checking and
setting the water hardness").
> Coffee temperature
(4) to set the coffee temperature.
> Auto off after : Turn the knob
to enter the time span after which the ap­
pliance should automatically switch to "en­
ergy saving mode" following the last drink
preparation. A time between 5 minutes and
8 hours can be set. The default time is one
hour, but this can be shortened to save
energy.
: The display contrast can
> Contrast
be set from –20 to +20 with the rotary knob
(4). The default setting is 0.
: The lighting can be
> Illumination
set to , or
Off On Off after 5 min.
setting: On ).
: Each time a new water
> Water filter
i lter is inserted in the water tank (12), it
must be rinsed:
1. Place the water i lter in the water tank
(12) and i ll the tank with water up to the
"max" mark.
2. Turn the rotary knob
and press
Press start
(8).
3. Place a container with a capacity of
0.5 litres under the milk frother (10).
4. Press start stop (8). Water will now
run i rst through the i lter to rinse it and
then into the container.
(4) to
: The per­cup
: Turn the knob
: Turn the knob
(4)
(factory
(4) to select
start stop
25.11.2011 16:02:04