Information And Settings; Displaying Information; Displaying Settings - Siemens TK76K573 Instruction Manual

Information and settings

Use (7) to display information (press
i
briefly) and adjust settings (hold down for at
least three seconds)�

Displaying information

In the Info menu (press
can call up the following information:
► when it is necessary to descale the
appliance
► when it is necessary to clean the
appliance
► when it is necessary to change the filter
► how much coffee has been dispensed
since the appliance was first put into
operation
► how many milk drinks have been
dispensed
► how much hot water has been prepared
Information / Service
....................................................................................
Descale after

Displaying settings

Hold down i (7) for at least 3 seconds;
the different setting options are then
displayed:
Default settings
Language:
English
Use < and
the different setting options� The currently
active setting is always highlighted in white�
You can change the setting that is currently
displayed by turning the rotary knob
To exit the menu, press
(7) briefly) you
i
100 cups
Per-cup quantities
> (3) to switch between
i (7) again�
The changes you have made
are saved automatically� It is
not necessary to confirm them
additionally�
The following setting options are available
to you:
> Language
select the display language�
> Per-cup quantities
quantity can be set separately for each
type of drink and each cup size (see "Set
per-cup quantity" on page 46)�
> Water hardness
(4) to select the required water hardness
(1, 2, 3 or 4) (refer also to "Checking and
setting the water hardness")�
> Coffee temperature
(4) to set the coffee temperature�
> Auto off after
(4) to enter the time span after which the
appliance should automatically switch off
following the last drink preparation� A time
between 5 minutes and 8 hours can be set�
The default time is 30 minutes, but this can
be shortened to save energy�
> Contrast
be set from –20 to +20 with the rotary knob
(4)� The default setting is 0�
> Illumination
set to Off ,
setting: On
> Water filter
filter is inserted in the water tank (12), it
must be rinsed:
1� Place the water filter in the water tank
(12) and fill the tank with water up to the
"max" mark�
2� Turn the rotary knob
Press start
(8)�
3� Place a container with a capacity of
0�5 litres under the milk frother (10)�
4� Press
(4)� run first through the filter to rinse it and
then into the container�
: Turn the knob
: The per-cup
: Turn the knob
: Turn the knob
: Turn the knob
: The display contrast can
: The lighting can be
On or Off after 5 min.
)�
: Each time a new water
(4) to select
and press
start stop (8)� Water will now
en de
(4) to
(factory
start stop
45