Check Points Of Every 50 Hours - Kubota ME8200DTN Workshop Manual Supplement

ME8200DTN, WSM

[3] CHECK POINTS OF EVERY 50 HOURS

Checking Engine Start System
Do not allow anyone near the tractor while testing.
If the tractor does not pass the test, do not operate the
tractor.
B Preparation before testing.
1. Place all shift lever and hydraulic levers in the "NEUTRAL".
2. Set the parking brake and stop the engine.
B Test 1 : Switch for the shuttle shift lever.
1. Sit on operator's seat.
2. Shift the shuttle shift lever to the forward or reverse position.
3. Depress the clutch pedal fully.
4. Disengage the PTO clutch control lever.
5. Pull out the engine emergency stop knob and turn the key to
"START" position.
6. The engine must not crank.
7. If it cranks, inspect the safety switch.
B Test 2 : Switch for the PTO clutch control lever.
1. Sit on operator's seat.
2. Engage the PTO clutch control lever.
3. Depress the clutch pedal fully.
4. Shift the shuttle shift lever to the neutral position.
5. Pull out the engine emergency stop knob and turn the key to
"START" position.
6. The engine must not crank.
7. If it cranks, inspect the safety switch.
(1) Shuttle Shift Lever
(2) Clutch Pedal
Checking Wheel Mounting Nuts Tightening Torque
Never operate tractor with a loose rim, wheel, or axle.
Any time bolts and nuts are loosened, retighten to
specified torque.
Check all bolts and nuts frequently and keep them tight.
1. Check the wheel mounting nuts regularly especially when
new. If there are loosened, tighten as follows.
Front wheel mounting
nut
Tightening torque Front disc mounting nut
Rear wheel mounting
nut and rear disc
mounting nut
(1) Front Wheel Mounting Nut
(2) Front Disc Mounting Nut
NG-9
GENERAL
(3) PTO Clutch Lever
0000003601E
166.7 to 196.1
17.0 to 20.0
122.9 to 144.6 ft-lbs
260 to 304
26.5 to 31.0
192 to 224 ft-lbs
260 to 304
26.5 to 31.0
192 to 224 ft-lbs
(3) Rear Wheel Mounting Nut and
Rear Disc Mounting Nut
0000003602E
KiSC issued 04, 2006 A