Stopping System; Checking - Kubota ME8200DTN Workshop Manual Supplement

ME8200DTN, WSM
As for the main switch, glow plug, PTO clutch safety switch and starter motor, refer to the ME8200
ME9000 Workshop Manual.

[3] STOPPING SYSTEM

(1) Checking

As for the engine stop solenoid, refer to the ME8200 ME9000 Workshop Manual.
Shuttle Neutral Switch
1. Disconnect the two 1P connector (3).
2. Connect the circuit tester to the safety switch (shuttle neutral
switch) leads.
3. Measure the resistance between leads.
4. If the safety switch (shuttle neutral switch) is defective, replace
it.
When operate the
shuttle lever to the
Resistance
forward or reverse
(Across switch terminal)
Shuttle lever at
neutral
(1) Shuttle Lever
(2) Safety Switch
Key Stop Relay
1. Remove the key stop relay (1).
2. Apply battery voltage across 1 and 2 terminals, and check for
continuity across 3 and 5 terminals.
3. If continuity is not established across 3 and 5 terminals, relay
is faulty.
The 4WD / Bi-speed relay (4), PTO relay (3), relay 1 (2) and
key stop relay (1) are interchangeable each other.
(1) Key Stop Relay
(2) Relay 1
N9-S8
ELECTRICAL SYSTEM
0
Infinity
(3) 1P Connector
0000003572E
0000003573E
(3) PTO Relay
(4) 4WD / Bi-speed Relay
0000003574E
0000003575E
KiSC issued 04, 2006 A