Mounting - Goodwe ET Series User Manual

2.3.2 Mounting

The inverter must not be installed near flammable or explosive materials or near
equipment with strong electromagnetism.
The inverter is suitable for mounting on concrete or other non-combustible surfaces only.
Step 1
Please use the mounting bracket as a template to drill 4 holes in the correct positions (e.g.
10mm in diameter and 80mm in depth).
Use the expansion bolts in the accessory box and tightly attach the mounting bracket to
the wall.
Note: The bearing capacity of the wall must be greater than 25kg. Otherwise, the wall may not be able to
prevent the inverter from dropping.
110mm 120mm
07
Step 2
Carry the inverter by holding the heat sink on two sides and place the inverter on the
mounting bracket.
Wall Bracket
Expansion Pipe
120mm
Self-Tapping Screws
Step 3
The ground cable shall be connected to the ground plate on the grid side.
Step 4
The inverters can be locked for anti-theft purposes if this is necessary for individual
requirements.
A lock is not included in the package
and can be purchased by the user.
08