Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle
regularly.
Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent.
Important: To avoid damaging the console, keep
liquids away from the console and keep the console
out of direct sunlight.
HOW TO INSTALL BATTERIES
The console requires two AA batteries; alkaline
batteries are recommended. Insert the batteries
into the battery compartment. Make sure that the
batteries are oriented as shown by the diagrams
inside the battery compartment. If there is a sheet of
clear plastic on the face of the console, remove it.
Note: You can set the console to display speed
and distance in either kilometers or miles. When
you insert batteries into the console, "KPH" will
begin to flash in the display. While "KPH" is flashing,
you can press the MODE button repeatedly to
switch between "KPH" (kilometers) and "MPH"
(miles). A few seconds after you have selected
"KPH" or "MPH," the unit of measurement will be
set.
BATTERIES REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries.
The console requires two 1,5V AA batteries; alkaline
batteries are recommended. Remove the battery
cover from the Console. Insert two batteries into the
console.
Make sure that the batteries are oriented as shown
by the diagram inside the console. Then, reattach
the battery cover.
11
Advertisement
Table of Contents
