Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and
mild soap. IMPORTANT: To avoid damage to the
console, keep liquids away from the console and
keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 7 on page 9
for replacement instructions. If the handgrip pulse sen-
sor does not function properly, see step 5 on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first use an adjustable wrench to turn the left
pedal clockwise and remove it. Next, remove the
screws from the left and right shields; there are two
sizes of screws in the shields–note which size of
screw you remove from each hole. Then, gently
remove the left shield.
Locate the Reed Switch (24). Turn the Crank (17)
until a Magnet (50) is aligned with the Reed Switch.
Next, loosen, but do not remove, the indicated M4 x
16mm Screw (62). Slide the Reed Switch slightly
closer to or away from the Magnet, and then retighten
the Screw. Turn the Crank for a moment. Repeat
these actions until the console displays correct feed-
back. When the Reed Switch is correctly adjusted,
reattach the left shield and the left pedal.
17
24 62
50
All manuals and user guides at all-guides.com
19
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
belt may need to be adjusted.
To adjust the belt, you must first remove the right
pedal and the right shield. Using an adjustable
wrench, turn the right pedal counterclockwise and
remove it. Next, remove the screws from the left and
right shields. Then, gently remove the right shield.
To tighten the belt, first loosen the M8 x 22mm Flat
Head Screw (67). Next, tighten the M10 x 90mm
Button Screw (69) until the Belt (18) is tight. Then,
retighten the Flat Head Screw. Reattach the right
shield and the right pedal.
67
18
69
Advertisement
Table of Contents
