Maintenance And Troubleshooting - Weslo pursuit R 1.2 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike
regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight. Remove the battery when storing the
exercise bike.
BATTERY REPLACEMENT
If the console does not function properly, replace the
battery (see assembly step 4 on page 6). In addi-
tion, make sure that the reed switch wire is plugged
fully into the console.
HOW TO TIGHTEN THE CRANK
If the arms
of the crank
become loose,
they should be
tightened in
order to pre-
Crank
vent excessive
wear. Loosen
the crank nut
on the left arm
of the crank.
Place the end
of a standard
screwdriver
in one of the slots in the slotted crank nut. Lightly
tap the screwdriver with a hammer to turn the slot-
ted crank nut counterclockwise until the arms are no
longer loose. Do not overtighten the slotted crank
nut. When the slotted crank nut is properly tightened,
retighten the crank nut.
Slotted
Crank
Nut
Nut
Crank
Arm
HOW TO ADJUST THE RESISTANCE STRAP
If there is not
enough pedal-
ing resistance
when the
resistance knob
is turned to the
highest setting,
the resistance
strap may need
to be adjusted.
To adjust the
resistance strap, first turn the resistance knob counter-
clockwise to the lowest setting. Next, locate the slotted
tab on the front of the exercise bike. Grip the longest
part the resistance strap underneath the slotted tab
and pull it towards the slot. When a little slack is cre-
ated, pull the end of the resistance strap tight. Turn the
crank for a moment to make sure that there is not too
much resistance.
HOW TO ADJUST THE CHAIN
The exercise bike features a chain that must be kept
properly adjusted. If the chain causes excessive noise
or slips as you pedal, the chain should be adjusted.
To tighten the
chain, loosen,
but do not
remove, the
axle nuts on
both sides of
the flywheel.
Pull the fly-
wheel forward
slightly. Make
sure that the
flywheel is
straight and
retighten the axle nuts.
11
Slotted
Tab
Resistance
Strap
Axle
Nut