Visual and daily maintenance inspections
4.2-3 Hydraulic
Do a check on these areas and make sure there are
no signs of leakage:
Hydraulic tank, gauge, filter, fittings, hoses
▪
Engine compartment fittings, hoses, primary
▪
pump, and filter
All hydraulic cylinders
▪
All hydraulic manifolds
▪
The ground area below the MEWP
▪
Outriggers (optional equipment).
▪
4.2-4 Wheel/tire assembly
Do the inspection that follows:
Wheel/tire assembly
1
Do a check on all the tire treads and sidewalls
▪
for cuts, cracks, and unusual wear.
Do a check on each wheel for damage, and
▪
cracked welds.
Make sure the wheels are correctly aligned
▪
vertically and horizontally.
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
▪
SJ9233 RT, SJ9243 RT, SJ9253 RT
Section 4 – Inspections Before Operation
1
WARNING
Do not use tires other than the tires that Skyjack
specifies for this MEWP . Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
Wheel nuts
2
Make sure the wheel nuts are installed and are
▪
tight.
2
221491AAA
37