Specifications - Wilson Electronics WILSONPRO ENTERPRISE 1300 Installation Manual

Specifications
Model Number
FCC ID
IC ID
Connectors
Antenna Impedance
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Noise Figure
Power Requirements
The term "IC" before the radio certification number only signifies that Industry Canada technical specifications were met.
Each Signal Amplifier is individually tested and factory set to ensure FCC compliance. The Amplifier cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Amplifier will amplify, but not alter incoming and outgoing signals in order to
increase coverage of authorized frequency bands only. If the Signal Amplifier is not in use for five minutes, it will reduce gain until
a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Amplifier detects an oscillation, the Signal
Amplifier will automatically turn the power off on that band. For a detected oscillation the Signal Amplifier will automatically resume
normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off
until the Signal Amplifier has been manually restarted by momentarily removing power from the Signal Amplifier. Noise power, gain,
and linearity are maintained by the Signal Amplifier's microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Wilson Electronics LLC could void the authority to operate this equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by Wilson Electronics LLC could void the authority to operate this equipment.
NEED HELP?
44
IN-BUILDING CELL SIGNAL AMPLIFIER
698-716 MHz, 729-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 Band12/17 700
MHz MHz
23.9
700 Band12/17 700
MHz MHz
16.7
support.wilsonpro.com
460149 / 460150
PWO460049 / PWO460050
4726A-460049 / 4726A-460050
N-Connectors
50 Ohms
Band13 800
MHz
23.9 25.1
Band13 800
MHz
16.8 16.9
5 dB nominal
120V AC 0.5A
ENTERPRISE 1300 & 1300R
1700 1900
MHz MHz
23.7 26.7
2100 1900
MHz MHz
16.8 16.8
866.294.1660