Danfoss AK-CS On Board Manual page 9

AK-CS
1/ Locate files to be sent to AK-CS
First, locate the files that require sending to the AK-cs - these should be located on the Pc. Use the tree structure in the left hand
window to navigate to the required files on the Pc.
2/ Connect to the AK-CS
Use the 'Connect' button to access the FtP server in the AK-cs - ensure the correct log in credentials are used. correct connection will
display the AK-cs directory in the right hand window.
3/ Transfer files
Make sure the correct AK-cs directory folder is opened up before sending downloading files. Use the --> button to transfer files from
the Pc to the AK-cs. the example below shows the files from the Pc (highlighted in blue) ready to be sent to the AK-cs directory.
once the file transfer process is underway, a progress bar will appear indicating the remaining files.
Updating AK-cs software
the function of remotely updating the AK-cs with new software (firmware) is possible using the rMt. the following steps should be
observed in order to correctly update the AK-cs
log on to AK-cs. note that after successful log on the log on button then reflects the log off function
1
9
User Guide
Usco.ei.rF0.A3.22.001 / 521U0146
lit. no.
After updating any eDF files or csdevice list the
AK-cs unit will require a re-set.
the relevant directory folder is opened, so that
the files from the Pc can be sent.
--> to download files from Pc to AK-cs
<-- to upload files from the AK-cs to Pc
User name = supervisor
Password = danfoss