Remote Management Tool (Rmt) - Danfoss AK-CS On Board Manual

AK-CS
For Modbus controllers, use the rs485 port and wire in daisy chain format (as
rs485 example above). note that Danfoss Modbus controls cannot be mixed with
carlo Gavazzi power meter, due to incompatible baud rates.
AK-CS RS485 version (mid network
connection)
this example shows the AK-cs rs485 version
used in the middle of a network run. in
this example ensure that both ends of the
controller run are fitted with 120 ohm
terminators.
terminator
(120 ohm)

remote Management tool (rMt)

the remote Management tool (rMt) is a complementary Pc software application tool that allows various remote management tasks
to be performed on the AK-cs. the rMt offers the following features;
VizEdit -
load custom store (bit map) graphic & map system data points to this image
remotely load image file to local AK-cs screen & web browser
FTP -
remotely connect, load and access system files
retrieve datapoints
Address Book -
save your most commonly connected site details to allow for one click connection
Tools- Download system software, backup (save) & load database file.
Language-
compatible in multi- languages
5
User Guide
AK-CS RS485 version
this example shows the AK-cs rs485 version. Both screen and Din models have a single
rs485 communication port. the rs485 network protocol must be wired in a 'daisy chain'
format - recommended that polarity is maintained.
Usco.ei.rF0.A3.22.001 / 521U0146
lit. no.
last device
terminator
(120 ohm)
terminator
(120 ohm)