Table of Contents
Advertisement
Instruction Manual
IM-103-400A, Rev. 1.0
December 2008
Section 3
INITIAL STARTUP AND
OPERATION
Initial Analyzer Startup
Figure 3-1. Range Multiplier
Switch
http://www.raihome.com
Startup and Operation
Initial Startup and Operation . . . . . . . . . . . . . . . . . . . . . . . page 3-1
Routine Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-8
Recommended Calibration Frequency . . . . . . . . . . . . . . . page 3-8
Shutdown . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-9
Obtaining Maximum Sensitivity . . . . . . . . . . . . . . . . . . . . page 3-9
The following paragraphs discuss initial startup, calibration procedures, use of
the range switch, and other operating topics for the Model 400A Hydrocarbon
Analyzer.
After installing analyzer per Section 2: Installation, perform the initial analyzer
startup and calibration procedure according to the following instructions:
1. Set the RANGE MULTIPLIER switch (located inside the small door on
the analyzer front panel) at 1000.
Model 400A
Advertisement
Table of Contents
