General Information
Coolant Temperature Gage
The coolant temperature gage indicates
the temperature of the engine coolant.
1
1.
Coolant temperature gage
When the ignition is switched on, all
eight bars of the display will be shown.
When the engine is started from cold
the display will show one bar. As the
temperature increases more bars in the
display will be shown. When the engine
is started from hot the display will show
the relevant number of bars, dependent
on engine temperature.
The
normal
temperature
between three and five bars.
If the coolant temperature becomes too
high the display will show eight bars and
will start to flash. The high coolant
temperature light in the tachometer will
also be illuminated.
Do not continue to run the engine if
either
of
the
warnings are displayed as severe
engine damage may result.
78
range
Caution
high
temperature
Fuel Gage
The fuel gage indicates the amount of
fuel in the tank.
2
1.
Fuel gage
2.
SET Button
With the ignition switched on, the
number of bars shown in the display
indicates the level of fuel.
When the fuel tank is full all eight bars
are displayed and when empty, no bars
are displayed. Other gage markings
indicate
intermediate
between full and empty.
is
When two bars are displayed the low
fuel warning light will illuminate. This
indicates
there
1.19 gallon (4.5 liters) of fuel remaining in
the tank and you should refuel at the
earliest opportunity. If a trip meter
display is shown, the range to empty
display can be selected by pressing and
releasing the SET button until it is
shown.
After refueling, the fuel gage and range
to empty information will be updated
only
while
Depending on the riding style, updating
could take up to five minutes.
1
fuel
are
approximately
riding
the
motorcycle.
levels