Installation And Connection; Mounting The Camera; Connecting The Wiring - Vanderbilt CCPS1317-LPOIR Configuration

4

Installation and Connection

4.1

Mounting the camera

4.2

Connecting the Wiring

© Vanderbilt 2016
1. Use the supplied mounting template to drill three 5mm mounting holes, and
then insert the supplied anchors into the holes.
2. Place the three provided washers onto the three tapping screws.
3. Insert the screws to the screw holes on the camera bracket, and then tighten
the screws to the anchors to attach the camera.
Recommendation:
To prevent the camera from falling off, we suggest to tighten a safety wire to a
firm place (ceiling slab or wall).
Note Depending on the material of your mounting surface, you may
require different screws and anchors than those supplied.
1. Pass all the signal cables through the mounting bracket.
2. Optionally connect a video monitor to the BNC connector if you want to
perform focus/zoom adjustments during the installation.
Safety Wire (fall prevention wire).
F 2.1 M
IGURE OUNTING THE
Installation and Connection
C
AMERA
9