Table of Contents
Advertisement
Administration and Configuration
5.8
PRIVACY
5.9
DAY/NIGHT
5.10
NOISE REDUCTION
© Vanderbilt 2016
Set PRIVACY function. The default setting is OFF. Move the joystick control
LEFT or RIGHT to select the ON mode then enter to the PRIVACY submenu.
You can configure 8 privacy positions, set 8 privacy areas, choose different color
zones and set transparency of 8 privacy zones. However if you enable the
MOTION DET function, the PRIVACY function will support 4 zones only. In
addition, the image of PRIVACY can allow you to set MOSAIC function.
The camera will automatically switch to Black and White (B/W) mode when the
illumination is under a certain threshold. There is no need to adjust this setting.
Under B/W mode, you can set BURST to be ON or OFF.
The camera option uses 28pcs IR LEDs for supplemental lighting. This allows the
camera to function under zero lux illumination when IR is on, creating an effective
IR illumination distance up to 25 meters.
You can configure the 2D DNR (Digital Noise Reduction) settings and reduce
noise on the screen. Enter the NR submenu as shown in the figure below. Move
the joystick control UP or DOWN to set NR MODE. When you enable the NR
MODE to the Y (BRIGHT) / C (COLOR), C LEVEL or Y LEVEL mode, you can
adjust Y LEVEL or C LEVEL depending on your environment condition.
Note
In dark areas, you can reduce the noise by increasing the Y Level,
while the color noise can be reduced by increasing the C Level.
PRIVACY
REA SEL
TOP
BOTTOM
LEFT
RIGHT
COLOR
TRANSP
MOSAIC
RETURN
NR
NR MODE
Y LEVEL
C LEVEL
RETURN
1/8
000
000
000
000
1
1.00
OFF
OFF
-
-
18
Advertisement
Table of Contents
