Autolink For Windows 3.X, Windows For Workgroups, And Dos - 3Com 3C589D User Manual

3-12 C
HAPTER
11 Click OK.
12 In the Network Adapters dialog box, click Close.
13 In the Network Setup dialog box, click OK.
14 If prompted, supply the information you gathered
before you began the installation. After you enter
the information, click OK.
A message appears, prompting you to restart your PC.
15 Click Continue instead.
16 If you are not using Card Services and you have a
memory manager (all PCs running Windows have a
memory manager), you must exclude the CIS memory
address range for the PC Card and other Card Services
devices.
For more information, see Appendix A.
The driver installation is complete.
AutoLink for Windows 3.x, Windows for Workgroups,
and DOS
If only one PC Card has been installed, you can use 3Com's
AutoLink
NetWare ODI client software (including the driver), and to
modify the CONFIG.SYS and AUTOEXEC.BAT files.
To use the AutoLink program, the PC must meet these
requirements:
To use the AutoLink program, follow these steps:
1 Make sure the 3C589D PC Card is installed and
connected to the network, as described in Chapter 2.
2 Boot the PC under DOS.
3 Insert the EtherDisk diskette into drive A, type the
following at the DOS prompt:
a:install [Enter]
3: I N
NSTALLING THE
™
software program to automatically install the
Use Novell NetWare 3.12, 4.10, or 4.11 network
operating system
Have only one 3C589D PC Card installed
Be intended for use as a NetWare DOS ODI client
D
ETWORK RIVER