3Com 3C589D User Manual page 24

13 Click Next.
The Network Services window appears.
14 Place a check mark in the box next to each desired
service.
15 Click Next to continue.
The next window states that Windwos NT is now ready to
install networking components that you selected and others
required by the system.
16 Click Next to install the selected components.
17 The Setup prompt states that Setup needs to copy
Windows NT files.
18 Enter the path to the Windows NT installation files
and click Continue.
This opens the Etherlink III PC Card dialog box.
19 Enter the settings for the PC card.
Select the appropriate settings for the card. In most cases,
the default settings will work, but if you are unsure about
what settings to use, ask your system administrator or MIS
department.
20 Click Continue.
If you are prompted for the bus type, select PCMCIA.
If prompted for the Bus number, select 0. Click OK.
21 Click OK to the next prompt.
22 If you selected TCP/IP and have a DHCP server, click Yes.
23 If you do not have a DHCP server, click No and get an IP
address from your system administrator and enter it.
Windows NT files are copied to the hard drive.
If you are prompted for TCP/IP information, enter it and
click OK.
The Network Setup Wizard shows a Bindings list.
24 Click Next to continue.
25 Click Next to allow Windows NT to start the network.
The Domain/Workgroup Settings window appears.
Windows NT 3-7