Back-Rest Tilt Adjustment; Side Guard Adjustment - OFF CARR DIVA Instruction Manual

3.6 Back-rest tilt adjustment

The back-rest tilt angle is fixed according to the choice on the order form. It is however possible, if allowed by the chosen
configuration, to change it if required.
• remove the "A" screw;
• select the new position of the back-rest;
• insert and tighten the "A" screw.
NOTE: if the choices in the "A" area are not enough it
is possible to act also in the "B" area to extend the
adjustment range.

3.7 Side guard adjustment

If necessary, act as following to change the position of the side guards:
PLASTIC SIDEGUARD:
• remove the "A" and "B" screws;
• choose the new desired position of the side
guard considering that the ideal gap between it
and tyre is about 6 mm;
• tighten the "A" and "B" screws being careful
to the original positioning of the washers and
spacers.
ALUMINIUM SIDEGUARD:
To allow a gradual adjustment, the aluminium
clothes guards is fixed through the "A" and "B"
screws to some dedicated slots on the frame:
• unscrew without removing the "A" and "B"
screws;
• choose the new desired position of the side
guard considering that the ideal gap between it
and the tyre is about 6 mm;
• tighten the "A" and "B" screws.
13