Operation; Faq - tams elektronik LD-G-6 Manual

English
CV-name
Operation of the
outputs X4 and
X5

Operation

Track sections with bad contacts (e.g. some types of points) may give
an unsatisfactory performance. You can improve the locomotive
performance by soldering a capacitor > 100 µF / 35 V to the points X3
and X15 (see fig. 1a and 1b).

FAQ

§
Parts are getting too hot and/or start to smoke.
!
Disconnect the system from the mains immediately!
Possible cause: one or more connections are soldered incorrectly.
à Check the connections.
Possible cause: The connection of the motor is connected to
locomotive ground.
à Disconnect the connection from locomotive ground.
§
The locomotive lighting does not correspond to its direction of travel.
Possible cause: The forward and reverse light connections have
been exchanged.
à Check the connections.
Page 36
CV- input
no. value /
(state of
delivery)
56 0 or 1
(1)
remarks
This data is set by entering the
sum of the numerical values.
Constant light
Lighting according to
direction of travel
LD-G-6
Numerical value
0
1