Operation Overview - tams elektronik LD-G-6 Manual

English
The configuration variables are saved in the decoder and are also
preserved if the locomotive is switched off. Changing the configuration
variables is possible at any time from the digital control unit.
The configuration variables for the DCC format are standarised. The
variables that can be set depend on the decoder type.

Operation overview

The decoder is designed for operation in DCC format and can be
adjusted to one of 127 basic adresses or to one of 10.239 extended
adresses. It evaluates the digital data sent by the central unit to its
address and transmitts it to the locomotive. It is designed to be
controlled from digital control units that are set on the 14- or the 28-
speed mode.
The configuration variables of the LD-G-5
The following configuration variables (CVs) can be set from the digital
control unit:
§
Basic address (CV 1)
§
Starting voltage (CV 2)
§
Acceleration rate (CV 3)
§
Braking rate (CV 4)
§
Maximum voltage (CV 5)
§
PWM-Period (CV 9)
§
Extended address (CV 17 and CV 18)
§
Consist-Address (CV 19)
§
Configuration data 1 (CV 29)
§
Operation of the outputs X4 and X5 (CV 56): lighting according to
the direction of travel for forward and reverse motion or a fixed
light.
Page 26
LD-G-6