Table of Contents
Advertisement
LD-G-6
The locomotive decoder outputs
The locomotive decoder has seven outputs that can be connected to
accessories that have a current consumption of maximum 500 mA each.
!
Caution:
The maximum total current of all connected loads including the motor is
3A!
Output X4
Output X5
Output X6
Output X7
Output X8
Output X9
Output X10
Function F0 (Light)
The lights for forward and reverse motion can be switched from the
digital control unit. You can either set the lighting according to the
direction of travel or a fixed light for both directions of travel by
programming the configuration variable CV 56.
Functions F1, F2, F4 to F6
These functions allow accessories connected to the assigned outputs to
be switched on or off. They are intended for optional accessories (e.g.
smoke generator, cab lighting, sound module).
Function F3
The Function F3 allows the switching to the shunting gear. This
facililtates a fine speed control for shunting operations at low speeds.
Higher speeds are not possible in this mode.
Light forward motion
Light reverse motion
Optional accessory, switched via function F1
Optional accessory, switched via function F2
Optional accessory, switched via function F4
Optional accessory, switched via function F6
Optional accessory, switched via function F5
English
Page 27
Advertisement
Table of Contents
